Reverse Engineering PCB Board Quality Assurance Provision
Reverse Engineering PCB Board Quality Assurance Provision included on the Government drawings such as Layout drawing, List of component, Gerber file and Schematic diagram are the documented requirements, procedures which include but not limited to the component de-soldering, measurement, procurement and assembly, criteria necessary for demonstrating that drawing conform to user requirements and, that material used for PCB Board manufacturing and associated services include manufacturing and assembly conform to approved designs.
Normally, QAPs should be prepared for inclusion on component, sub-assembly, and assembly drawings.
QAPs are not required for the following:
- Components, sub-assemblies, or assemblies that are not required for installation in the maintenance or repair of PCB Board, sub-assembly, or component (except those destined for use in modifications, reconditioning, or retrofit programs),
- Commercial, proprietary, or off-the-shelf items, unless modified, or where specific performance requirements are necessary for the military application,
- Simple items such as nuts, bolts, washers, locks, hinges, etc., except when these items are employed for critical usage or high accuracy is required,
- Items not supported by detail drawings whose requirements are contained in a detail specification, and
- Components, such as, springs, gears, etc., having like characteristics and that are applicable to a category of related items. In such cases, the QAP should be included in the specification for those items.