Fixing Siemens X-Ray Generator Circuit Board Module starts from failure judgement analysis, through fault detection program and measurement methods:
first of all, Find by fault detection program is the easist way to access one, under normal circumstances, when Siemens X-Ray Generator fails, most of it can be detected by its own program to determine the cause of the failure. There are two main types: one is a problem with its own program; the other is a failure with some circuit board modules need to be rehabilitated;
second is through the measurement method which is a relatively common method. It mainly uses equipment such as a multimeter to detect the status of the output and input of each group of the circuit board modules, and determines the cause of the failure by detecting the voltage.
However, this method requires that the relevant equipment personnel and maintenance personnel must be quite familiar with the principle of use of the equipment and the understanding of various machine parts and components, and be able to accurately determine the value of the voltage under normal conditions through normal means especially in the condition of wiring schematic of PCB board module absence which can be recovered. General basic common sense, test the voltage before the official use, and then correctly record its value, and finally refer to the previous data in daily maintenance to complete the inspection and maintenance work.
The third method is Elimination method, it is to make a reasonable investigation based on the actual fault situation before making an accurate judgment. The final result obtained in this way is likely to be the cause of the final failure. As for the circuit board, detecting whether it is faulty is a relatively complicated task. You must judge it by repeatedly testing the connection. However, once a fault occurs, it is difficult to connect the circuit board to build the whole system for testing.