Clone Electronic PCB Card in Automobile starts from restore PCB board design drawing and gerber file from automobile PCB card sample, not like the standard procedures for the PCB design stage is to convert the schematic design into an actual processable PCB circuit board. the procedures will be carried on in the reverse order.
At present, the mainstream PCB design software includes PADS, Candence and Protel. PCB design, especially high-speed PCB reverse engineering, needs to consider EMC/EMI, impedance control, signal quality, etc., which requires relatively high requirements for PCB designers. In order to verify whether the designed PCB meets the requirements, some PCB simulations are also required.
And adjust the PCB layout and routing according to the simulation results to complete the entire design. After the automobile PCB card drawing is completed, at this stage, we need to generate a processing file that can be recognized by the processing plant, which is often referred to as a light drawing file, and send it to the circuit board manufacturer to verify our extracted pcb layout file through the empty PCB board. Generally, 1~4 layer boards can be manufactured within a week.