PCB Reverse Engineering technology is used to reversely analyze the printed circuit board, and to acquire the Layout Drawing, Gerber File, Bill of materials (BOM), Schematic diagram and designators drawing are restored in the aspect ratio of 1:1, and then these technical documents and production files are used for PCB board remanufacturing, component soldering, flying probe testing, circuit board debugging, and complete replication of the original circuit board.
One of the main aspect of reverse engineering Electronic PCB Board is studying component and track connection processing technology in the netlist table generation process, the technology research is how to analyze the component information and electrical wire connection information by extracting from printed circuit board image and provide source data for netlist table generation;…
The netlist is an important document generated during the PCB Clone Service. It is a bridge between the electrical schematic and the PCB board. As the name suggests, the network table is the definition of the electrical connection between the components in the schematic diagram. It is the textual representation of the component-connected network extracted…
Reverse Engineering Multilayer PCB Card will encounter the difficulty of invisiable wires buried in the inner layer, even though most of the wires among inner layers are all used for grounding and power supply and play as the isolation sheet, but it is still critical for the success of PCB Reverse engineering; For invisible lines,…
As an intuitive form of expression, graphic pictures have more information capacity than text information, and drawed more and more people’s attention in the Reverse Engineering Electronic PCB Card Component Connection Treatment. In order to express the component connection information more intuitively, a graphical expression with strong interactive ability and rich information is adopted. When…
Reverse Engineering Printed Circuit Board is to obtain the schematic diagram based on the board image. The key technologies involved are image processing, image recognition, component and line connection processing, network table generation and automatic generation of schematics. The study is focusing on the component and line connection processing techniques in the network table generation…
PCB Board Copying Gerber File extracted from the physical PCB sample through reverse engineering technique needs to be test through composite testing, and a composite tester is an instrument that integrates online and functional tests into one system. The PCB after manufactured is first tested online through a needle bed, and then the PCB is…
After we reverse engineering PCB board physical sample and acquire PCB Cloning Gerber File, it is necessary to perform the testing on the PCB prototype which is manufacturing base upon the gerber file acquire through PCB Board cloning technique. at this senarios, the PCB tester will be applied for the circuitry pattern testing to ensure…
The following describes a commonly used method about how to Clone PCB Board Gerber File, the process is as follows: The first step: first record the model, parameters, and position of all the components on the paper, especially the direction of the diode, the triode, inductor and transistor, the direction of the integrated circuits notch.…
The basic principle of the PCB Reverse Engineering Software is: with the aid of the PCB Reverse Engineering software, the operator draws the layout drawing of printed circuit board according to the physical PCB board, and reversely generates the network table of the common format of the PCB board, and then the operator import the…
During the period from the early stage of reform and opening up to the end of the 1980s, due to the huge gap in technology level, China relied mainly on foreign engineers for the maintenance of electronic devices for imported equipment. The desire to increase the utilization of imported equipment and reduce maintenance costs has…