After the Simulation Model of Automobile Windows Electronic Switch PCB Board cloning is established, various analysis conditions can be set for it.
Right-click the stimulus in the project box, and the Add Port option (Add Port) appears on the menu.
Before adding a port, you need to select the edge to which the stimulus needs to be added.
Set analysis conditions (Analysis)
Right-click the analysis option in the project box, select “Adding Solution Setup” from the menu that appears, and under the Meshing Parameter tab, initialize the mesh to a fixed mesh (Fixed Mesh), the frequency is set to 1 GHz;
Under the Mesh Refinement tab, the Refinement Parameters accept the default values.
Set frequency
Set its type and sweep start frequency, stop frequency and step length. The start frequency of the sweep is set to 100 MHz, the stop frequency is set to 0.9 GHz, and the step size is set to 200 MHz, a total of 5 frequency points.
After the analysis conditions are set, click the Planar EM menu and select Validation Check to verify the set parameters. If it is unqualified, modify the error according to the prompts and verify again until it is qualified. After successful verification, click Analysis to start analyzing the PCB board cloning simulation model.