PCB Board is important component in the electronic product, is the carrier of electronic components and electricity connection provider. Traditional PCB Board use printed etching and solder resistance method to produce the circuitry pattern which comes its name. due to the increasing minimization and finest, most of the PCB Boards are applying the adhesive etching…
ESD Suppression on Electronic Board Cloning When engineer execute Electronic Board Cloning, there will be a criterion on the procedures of ESD suppression, through cloning the layout and gerber file can be extracted and then carry on the re-design to reduce the electronic magnetic static discharge effect on the whole system: Circuit connection length A long…
PCB Card Reverse Engineering will help to reduces unnecessary costs associated with troubleshooting and rework. In PCB Card Reverse Engineering, due to the use of transient voltage suppressor (TVS) diodes to suppress direct charge injection due to ESD discharge, it is more important in PCB Card Reverse Engineering to overcome the electromagnetic interference (EMI) electromagnetic…
Clone High Riser Backplanes Circuit Board Gerber File needs to desolder all of the components on the high riser backplane off and strip off the solder mask covered on it, to get a fully exposed circuit board, and before the improvement of FPGA lead hasn’t completed, designer has already reported the information to the supervisor…
The detail plan of this level consume only 30 seconds to complete the task, once this plan has been obtained, the engineer will probably want to Reverse Engineering PCIE Backplane Gerber File or create the topology plan for next layer immediately, and then use automatically layout to finish all of the topology plan. From…
Accompany with the DATA-BUS being organized into the tight trace by tissue on the first layer, designer start to plan the detail #3 to the 3rd layer’s conversion. And considering the matching distance of the Server Backplane Board, please notice, this topology route on the 3rd layer must be wider than the top layer, and…
Engineer need to apply topology plan in the process of Chassis Backplane Card Cloning, through the interaction of components on the already finished layout and semi-finished layout to achieve the best layout and interconnection, as a result of that, to improve Chassis Backplane Card Cloning efficiency. Accompany with the accomplishment of the topology plan and…
Reverse Engineering Backplane Card can use IP, the application of topology plan and layout tools to support the IP, consequently finish the whole Backplane Card reverse engineering process in a faster way than before. Engineer’s responsibility is through layout as few necessary components as possible, and make critical interconnecting route among these parts to obtain…
Value Engineering of PCB Cloning Value Engineering objective A value engineering (VE) review of PCB Cloning candidates may reveal cost drivers over and beyond the sole source restrictions. Some probable high cost drivers are: excessive material requirements such as the capacitor, resistor, inductor and integrated circuits, PCB layout drawing defects, over design, functional redundancy, tolerance…
Printed Circuit Board Reverse Engineering Recommendation Product improvement is one of the main purpose for Printed Circuit Board Reverse Engineering 1st aspect is Inadequate data The items, as documented during the printed circuit board reverse engineering process, may not have been previously considered for printed circuit board improvement because of inadequate data, these datas might include Layout…