Daily Archives: August 14, 2018

Part Identification in PCB Reverse Engineering

Part Identification in PCB Reverse Engineering After disassembly each piece-part/component in PCB reverse engineering process should be researched to identify existing NSNs, commercially available hardware, MIL-STD parts, and non-standard parts. Economic analysis. An economic analysis should be performed on all sole-source and non-standard piece-parts/components to determine the cost-effectiveness of reverse engineering PCB’s piece-part/component. A limited…

Disassembly PCB Board Reverse Engineering Target

When Disassembly PCB Board Reverse Engineering Target, notes should be recorded for possible assembly procedures to be included in the Technical data package. As they are disassembled, a list of all piece-parts/components should be created, including quantities and special part markings which may indicate that the part is either commercially available or a military specifications…

PC Board Reverse Engineering Initial Inspection

Post-PC Board shipment inspection To preclude the replication of defects, the PC Board Reverse Engineering Initial Inspection for possible damage in shipment. sometimes the PC board sent from customers may have the faulty or malfunction problem such as the burn out capacitor, incapable integrated circuit or mis-match oscillators, unshaped terminal block or pin header. we…