LVDS Output on Multi-Function Recorder PCB Reverse Engineering LVDS Output on Multi-Function Recorder PCB Reverse Engineering for high performance ADCs should be treated differently than standard LVDS outputs used in digital logic. While standard LVDS can drive 1 meter to 10 meters in high speed digital applications (dependent on data rate), it is not recommended…
LVDS Logic in Switch Panel Circuit Board Reverse Engineering Recently, LVDS logic in Switch panel circuit board reverse engineering (low-voltage-differential-signaling) has attained widespread popularity because of similar characteristics, but with lower amplitudes and lower power dissipation than ECL. The defining LVDS specification can be found in the References. The LVDS logic swing is typically 350…
Source Termination in Trim Module PCB Card Cloning How Source Terminations in Trim Module PCB Card Cloning can be used in bidirectional link port transmissions between SHARC DSPs. The output impedance of the SHARC driver is approximately 17, and therefore a 33 series resistor is required on each end of the transmission line for proper…